Firmware update

You can update the firmware of the printer, check the firmware version, or perform settings of a notification screen, a DNS server and a proxy server.

Important

• The administrator password is required to change the settings if it is enabled to change the settings on the operation panel using the administrator password.

• When you use this function, make sure the printer is connected to the Internet.

Note

• Check current version and Update notification settings are available when Disable is selected for Enable/disable Wi-Fi of Wi-Fi in LAN settings.

• Install update

  Performs the firmware update of the printer. If you select Yes, the firmware update starts. Follow the on-screen instructions to perform update.

  Note

  • If the firmware update is not complete, check the following and take an appropriate action.

    • Check the network settings.

    • If Cannot connect to the server. is displayed on the touch screen, select OK and try again after a while.

• Check current version

  You can check the current firmware version.

• Update notification settings

  When ON is selected and the firmware update is available, the screen to inform you of the firmware update is displayed on the touch screen.

• DNS server setup

  Performs settings for a DNS server. Select Auto setup or Manual setup. If you select Manual setup, follow the display on the touch screen to perform settings.

• Proxy server setup

  Performs settings for a proxy server. Follow the display on the touch screen to perform settings.